There are thousands of bears on this line, the original ones are genuine, because they have a lot of goods, they are cheap to deal with. It is not that the line is not good. It turns out to be an accessory on a mobile phone. Each has a separate small package, which is suitable for all Android micro usb belts. otg-enabled mobile phone(Can''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''t use without OTG function)
OTG function: can connect to USB peripherals such as mouse, keyboard, handle, U disk, etc. Use usb hub to connect the TV HD cable to play games and watch videos
Power supply requirements: because some USB peripherals have higher voltage requirements, there is no guarantee that all USB peripherals can be compatible. Please be aware that no disputes
Technical application development: some function development of OTG requires a rooted mobile phone
This shop does not provide software technical support services because it is very complicated. Don’t because you don’t know how to use it. It’s bad to miss the line. Thank you
The weight of the product is as follows, with packaging weighing 13.2 grams.
The actual product is as shown in the figure below. All are individually packaged and the condition is very new. Because of the large quantities of bulk delivery, the bear is cheap.
After removing the packaging, it is recommended to cut the paper and use it. It will be a little inconvenient to use the paper without removing the paper. The glue in the paper sleeve will get dirty after a long time.
The product label paper was originally used on a power bank. The actual test can also be used as an OTG cable. Because the cable is full of needles, you can see the disassembly diagram below.
What the other side of the label looks like.
Another label picture, brand, Model number, output power.
Let''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''s have another one on the other side.
The interface work is fairly meticulous.
Take a look, the thick oneCopper screen shield, four data lines of red, white, green and black.
Disassemble the connector and take a look. The seal can be done. The glue inside is cut a little with a knife. You can see that the thread is full of needles and all connected.
Disassemble the other endMIcro mouth
Take a look at each of the corners of the jelly. See that one angle is missing.
Looking at it on the other hand, it turned out that this side was received, and all of them were connected.