Tips
Dear,Every product will go through our strict inspection before shipment.Before you install,First compare the original car standard to determine the appropriate installation,Parallel12VThe power test is no problem, then tear off the double-sided tape on the back of the product and install it to the corresponding position on the car.If you have torn off the double-sided tape and affixed it to the car,You cannot return or exchange the goods!Thank you for your understanding and support!Thanks for your cooperation!
We provide 6 months warranty service
Features:
1. The appearance of this product is consistent with the original car logo. It is installed in the tail box of the car and can directly replace the original car logo. Its special vacuum electroplating technology not only guarantees the gloss consistency with the original car logo, but also guarantees high light transmittance and uniform brightness.
2. The use of high-quality LED lights has the characteristics of high brightness and long service life. The special design is waterproof and dustproof to ensure long-term use.
3. This product is specially designed for car modification enthusiasts. When the car logo lights are not on during the day, it is no different from the original car logo. When the night license plate lighting is turned on, the LED car logo lights will also light up. Make the car logo become dazzling in the dark, full of futuristic sense of science and technology, demonstrating the noble pedigree of your car.
4. The inside LED light adopts special waterproof and dustproof design! The life span of the LED lamp is as long as 100,000 hours.
5. The use of high-quality automotive double-sided adhesive, strong and long-lasting adhesion!
【Post standard size】
10CM*6.8CM, 10.2CM*6.82CM, 11CM*7.5CM , 1.2CM*7.55CM, 11.7CM*8.2CM, 12CM*8CM, 12.2CM*8.05CM, 13CM*8.9CM, 13.2CM*8.9CM
【Front standard size】
14CM*9.5CM, 14.1CM*9.5CM, 15CM*10CM, 16CM*11CM, 16CM*11.2CM
【color】Red white blue
【power supply】DC12V+/-10%
【Wiring length】0.6 meters
【power】2(W)
【Voltage】12(V)
【Current】0.1(A)
【Tools prepared before installation】
Before you start, please prepare the following tools: 1. Flat-head screwdriver 2. Phillips screwdriver 3. Insulating tape 4. Towel 5. Pliers
【Installation Notes】
1. First lay a towel next to the logo of the boot, and use a flat-head screwdriver to pry the logo. The towel is to prevent the car from being scratched.
2. Pay attention to peel off the double-sided tape from the car body first. Use moderate force when prying. Don''''''''''''''''''''''''''''''''t pry it too hard. Slowly pry it down. Clean the car logo and the double-sided tape on the body.
3. Use a Phillips screwdriver to remove the partition inside the tail box, pay attention to some parts of the clip, be careful to remove the sound insulation board to see all kinds of lines.
4. Now let’s install the beacon lights again. The power cord of the beacon light passes through one of the logo positioning holes and penetrates into the car box. Remove the single-sided glue on the back of the beacon light, and glue the beacon light to the body while pulling the wire. , Squeeze.
5. The beacon lights are installed, now connect to the power supply. The car beacon light should be connected to the power supply of the rear license plate light, so that when the night light is turned on, the car beacon light will also be turned on at the same time. Find the power connector of the rear license plate light.
6. First unplug the plug, strip each of the positive and negative poles to expose the core of the wire, press red to red, and black to black to connect the wires, don’t forget to wrap them with insulating tape, and finally plug the plug back in again. ! Replace the tail box cover sound insulation board.