![](https://img.alicdn.com/imgextra/i4/T2s4moXH8XXXXXXXXX-350475995.png?p=hbtuiguang_195921_start_top_1)
![](https://img.alicdn.com/imgextra/i4/T2s4moXH8XXXXXXXXX-350475995.png?p=hbtuiguang_195921_end_top_1)
![](https://img.alicdn.com/imgextra/i3/653367015/T2oBrgXBXXXXXXXXXX_!!653367015.jpg)
![](https://img.alicdn.com/imgextra/i2/653367015/T2rKfhXvXXXXXXXXXX_!!653367015.jpg)
![](https://img.alicdn.com/imgextra/i1/653367015/T2TA2gXBdXXXXXXXXX_!!653367015.jpg)
![](https://img.alicdn.com/imgextra/i2/653367015/T2qOvfXwJaXXXXXXXX_!!653367015.jpg)
Shenniu Studio Flash DC Trigger Trigger AT-16Flash trigger product description:
1. Long-distance, omni-directional barrier-free triggering of flash studio lights and outdoor flashes.
2. The power consumption is extremely low, the transmitter can work for up to one year on a battery stand-by, and can be triggered continuously for up to 10,000 times, and the trigger current is only 0.01 mA.
3. Low working cost.
4. Sixteen working channels do not interfere with each other.
The main parameters of AT-16 flash trigger:
1. Transmitter power supply: 23A 12V small battery.
2. Receiver power supply: AC 100V-240V.
3. Outdoor working distance(Open ground)?25-30 meters.
4. Indoor working distance?25m.
5. Synchronization speed: 1/200 second.
6. Radio frequency: 433MHZ(Can not be used with the old model)
How to use RT-16 flash trigger:
A. Pull the frequency changeover switch (7) of the receiver and the frequency changeover switch (7) of the transmitter to the same position.
B. Insert the trigger output plug of the receiver into the sync socket of the studio light.
C. Connect the AC100V-240V power supply(11)Receiver power socket.
D. Press the transmitter test flash button (9) and the trigger signal indicator light (6) of the receiver flashes, and the receiver signal indicator light(10)On at the same time, trigger the studio light to flash at the same time
Light work.
E. Insert the hot shoe socket (8) of the transmitter into the hot shoe socket of the camera to work normally.
F. If the camera does not have a hot shoe, you need to insert one end of the equipped sync cable into the sync jack (1) of the transmitter and the other end into the sync jack of the camera.
Precautions for using AT-16 flash trigger:
1. The battery used must be consistent with this machine.
2. When the battery is about to run out, the receiver stops working, please update the battery.
3. Avoid falling and colliding with hard objects.
4. Confirm the trigger mode of the studio flashlight before use.
5. If other radio waves are used in the field, flash leakage may occur.