★ Pre -purchase statement:
1. This product only sells patients with patience, and the customer is impatient.
2. Be sure to read the instructions carefully before posting,(If you do not receive the instructions and the customer service requires an electronic version)Don''t post for more than half, you haven''t found a clue, and then come back to see the manual late, you need to post it in order.
3: You can consult customer service assistance if you do n’t post or other questions.
★ Preparation before posting:
1: Prepare tools: Hair dryer(If you don''t have a lighter, you can find a lighter), Duzi, cutting knife, alcohol bag, cleaning cloth.
2: Wash your hands, prepare a clean plane desk or workbench, sit down in a quiet and shiny environment and relax.
★ Working in the post:
1: After receiving it, you can remove the extra stickers according to the hollow in the drawing, and pull out all the internal round holes and alien waste paper.
2: Wipe the camera in the sticker first. After drying, you can study the corresponding position of each hole position.
3: Most of the correct order in the stickers are: first with many holes, then the area with small pieces, first start from the top, then stick the front and rear holes, and then stick the bottom and skin.Each to two stickers are heated with a hair dryer to flatten the edge once.
★ Note:
1: The difficulty is the part with many holes. Be sure to align carefully. Pastening can be unveiled multiple tests. Carbon fiber has telescope.(hair dryer)Heating for one or two seconds is stretched. If it encounters about 1 mm, it is too large, just heat it.
2: Be sure to align the holes and then flatten and press it. If you encounter a large porous sticker, you can try to cut two half from the details to reduce the difficulty of the film.Align the hole and then flatten it in the middle. If there is a protruding part that does not fit, the raised part is eliminated by tailoring, and the left and right are flattened.
3: Press all the small pieces of each small piece, and then heat it, then heat the fixed corner. After all the work can be heated again, it can be pressed again to ensure that each piece is completely fitted with the camera.This is a testing process that tests patient. Dear friends must be patient, work quietly, be anxious, but slow but not to be done.(Lens)Anti -grinding, overall effect of beauty cameras.
★★★★★★ This camera passed the real machine test of the store to ensure that it is in place. There is no waste discharge by the post. After the abolition of scraps in advance, according to the district difference, it is easy to start on the road and the sun is easy to start on the side., So if you do n’t have to be emptied, please exclude the useless waste paper after receiving it.You can post it from top to bottom. Start from the hood area, align the holes when the sticker, and then smooth it. The lighter or a hair dryer is not easy to raise the side.★★★★★
Here
In 15 minutes, there are some diced flaws and no post -picture processing. The store believes that 98%of the skills have been done. I hope that the buyers later will continue to work hard to achieve the effect.