note:The hood has nothing to do with the body model, Please confirm the lens model you are using so that you can choose the correct lens hood(Otherwise can not be used), If you are not sure, please consult customer service. Install the lens hood until you hear the click sound and then it is installed.Make sure to install it in place, otherwise it will loosen and fall off.
![](https://img.alicdn.com/imgextra/i1/1695966948/T2KCD7XXdXXXXXXXXX_!!1695966948.jpg)
【model】:EW-53 Lotus Bayonet Lens Hood
【colour】:Black
【Material】:Advanced ABS engineering plastics
【Can you deduct】:Support deduction
【Scope of application】:CanonThe following lenses used by Mirrorless EOS M100/M50/M10/M6/M5/M3, etc.:EF-M 15-45mm f/3.5-6.3 IS STM lens
【Function introduction】:Block unnecessary incident light, suppress the generation of ghost and flare; anti-drop and anti-collision protect the lens
【Tips】:The hood, UV lens, and lens cover can be used at the same time without affecting each other.
【installation method】:See the picture below ↓↓↓Make sure to install it in place, otherwise it will loosen and fall off.
![](https://img.alicdn.com/imgextra/i4/1695966948/T2oUH6Xi4XXXXXXXXX_!!1695966948.jpg)
![](https://img.alicdn.com/imgextra/i1/1695966948/O1CN0121CEKDHGQFKfCJn_!!1695966948.jpg)
![](https://img.alicdn.com/imgextra/i1/1695966948/O1CN0121CEKJwhNG7BhjW_!!1695966948.jpg)
![](https://img.alicdn.com/imgextra/i4/1695966948/O1CN0121CEKKB8xG7HgIx_!!1695966948.jpg)
Note: In order to improve the product, all design/appearance/parameter changes have not been updated in time, please refer to the actual product.
【The role of the hood】:
Lens hoods are commonly used photographic accessories set in front of the camera lens. They are available in metal, hard plastic, and soft rubber. It has the following functions:
1. In the backlight, side light or flash photography, it can prevent the entry of non-imaging light and avoid fog.
2. It can avoid the surrounding scattered light from entering the lens when shooting with forward light and side light.
3. In lighting photography or night photography, it can prevent the surrounding interference light from entering the lens.
4. It can prevent accidental damage to the lens, and it can also prevent fingers from accidentally touching the surface of the lens. It can also shield the lens from wind, sand, rain and snow to some extent.
Lens hoods are widely used in backlight photography, generally speaking, to avoid glare. However, if the light source is close, glare may still occur. At this time, you can use your hand to block the hood on the side where the light source is located. Whether the glare is eliminated, you must observe it clearly in the viewfinder.